Skip to main content

Professional Services

 


ETL can provide a quote for the following professional services, either based at the ETL factory or on-site:

Product or System Training

Your personnel can be trained either on-site or at ETL's factory, which could include witnessing compliance to RF parameters. Training areas offered include:

  • Confirmation of test results of key RF data
  • Integration and installation of ETL RF equipment
  • Normal Operation of the RF equipment
  • Troubleshooting - Upgrades and servicing
  • Hot-swap features
  • Overview & Operation of ETL PC Software 
  • Choice of partial or full FAT (Factory Acceptance Test)
  • Training manuals and certificates issued

Onsite Commissioning Visit

Trained RF Engineers can travel to your site to support commissioning and training visit. Commissioning visits can include:

  • Sample test on RF cables and check that communications cabling is correctly connected.
  • Check commands / communications for RF equipment
  • Test live signal through the RF equipment
  • Sample RF testing (check a small number of samples of key parameters like isolation and insertion loss) 
  • Training overview to key personnel - to demonstrate normal operations, system cabling, diagnosis and change-out of active components 
  • Handover of ETL RF Equipment
  • Training manuals and certificates issued

On site installation and commissioning visit

Trained RF Engineers can travel to your site to carry out installation and commissioning visit:

  • Unpacking equipment and fitting into 19" racks
  • Tidily fit the RF cables into the racks and terminate one end
  • Continuity Test the RF cables for good terminations
  • Connect cables to ETL RF equipment
  • Fit the inter-unit communications cabling
  • Check routing commands / communications for the whole ETL RF system
  • Connect RF in and out cables to ETL RF system
  • Test live signal through the ETL RF system
  • Sample RF testing (check a small number of samples of key parameters like isolation and insertion loss) 
  • Training overview - to demonstrate normal operations, system cabling, diagnosis and change-out of active components. Further sample RF testing to demonstrate compliance.
  • Handover of ETL RF Equipment
  • Training manuals and certificates issued